Thermostat and Humidistat
Guide summarizing the main features of the thermostat; the steps described apply to the humidistat and, in general, to the management of any sensor for which control has been activated.
Thermostat and Humidistat Management
The app allows you to adjust the temperature, create weekly events (for automatic management), and recognize when the associated load (e.g., a solenoid valve) is activated. In this brief guide, we will show a simple example.
Once the app is opened, click on the room/group whose temperature you want to adjust. In the example provided, we will modify the setting for the Living Room.
Sensors Page
Select the Sensors page (button located in the bottom bar) to view thermostats, humidistats, sensors, etc., present in that room/group.
In the image, you can see only one thermostat; the graphics easily allow us to understand the current configuration:
transparency and the
OFFlabel indicate that it is currently offthe measured temperature is 22.4°C
Click on the thermostat to modify the settings.
Activation and Adjustment
Once clicked on the thermostat, we find the following page.
To activate the thermostat, click on the switch in the Activation section.
To adjust the temperature, you can use the + and - buttons or click on the value to directly enter the setpoint. If the thermostat allows both heating and cooling control, you can define the mode in the dedicated section.
For now, let's activate the thermostat and set the temperature to 23°C. Then press the blue button at the bottom right to confirm.
Once saved, the thermostat graphics will appear as follows.
Where "OFF" appeared before, now the setpoint of 22.5°C is displayed, and the thermostat is no longer transparent.
The bright red background, with the setpoint displayed, indicates the "heat call" of the thermostat, meaning the associated loads (e.g., solenoid valve) will be activated.
If the environment reaches the set temperature, the bright red background will appear less intense, as shown in the following image.
Calendar
To activate automatic management of the thermostat, you can configure events in the dedicated calendar.
To access the calendar, simply click on the dedicated icon present on the thermostat. You can also access the calendar from the settings by scrolling down to the Calendar section.
Once the calendar page is open, you can click on the + button at the bottom right.
A page with various options will open, including:
possibility to define a name
selector to activate/deactivate the event
selection of the days of the week
start and end time of the event
setting of the setpoint and mode
whether to activate or deactivate the thermostat during that time slot
option to deactivate the thermostat at the end of the event
The "Deactivate at end of event" option (active by default) allows the thermostat to be automatically turned off at the end of the time slot.
Often, you may not want to completely turn off the thermostat but rather adjust the setpoint to a lower/higher value (depending on whether we are talking about heating or cooling); to do this, it is necessary to deactivate this option and create other events with the desired setpoint.
If there are active events, the calendar icon will be displayed in blue.
Events are set to have an impulsive management by default, so even if you are in one of the time slots you configured, you can still manually adjust the setpoint; this temporary setting will be maintained until a new event is executed.
Example
In the event below, we selected all weekdays and defined the time slot from 05:00 to 08:00.
Next, let's set the temperature to 20°C and choose Heat as the mode. Additionally, we'll deactivate the End event disable option to prevent the thermostat from being turned off at the end of the time slot.
Then, press Save at the top right to confirm our configuration.
Tips
Pressing and holding on the thermostat will bring up a simpler interface, allowing you to quickly adjust the settings.
You can also quickly access the thermostat by tapping on the temperature value displayed on the rooms/groups of the main screen; in this case too, a long press will display the quick setting screen.
Last updated
